Product overview
Overtake is the NEW herbicide from Syngenta offering broad spectrum weed control. Overtake contains Fluroxypyr and Florasulam.
These two active ingredients in one great combination provides:
- increased spectrum of weeds controlled
- greater relaiability in a wider range of temperatures and conditions
- 2 different modes of action
- reduced risk of weed resistance developing
- novel suspo-emulsion formulation to maximise performance
Overtake offers broad spectrum weed control
A spring application of Overtake can clean out turf of weed competition for stronger turf growth and recovery, an improved playing surface and more efficient use of fertiliser, water and other inputs. Deliver the quality turf you want - not the weeds that you don't.
Apply when weeds are actively growing in the spring to target smaller, immature weeds when they are more susceptible.
Overtake saves you time
Reliable results first time and optimum performance at 200 l/ha provides you more efficient spraying.
Outstanding turf safety with Overtake
Over 70 trials across 9 countries has proved the safety of Overtake on turf along with performance against a wide spectrum of weeds under different conditions.
- No hold up in spring turf recovery
- Reduced risk if weather conditions change after application
- Extensive trials for safety on turf species
Get the best from Overtake application
- Apply in spring when weeds are actively growing
- Apply at 200 l/ha water volume
- Spray using Syngenta Turf XC nozzles - 025 or 04
- Avoid application to weeds or turf under stress
- Wait three days after application before mowing
Classification and Security
Hazard Statements |
|
---|---|
Precautionary Statements |
|
Other Restriction of Use |
Broad-leaved weeds not present at application will not be controlled. Clippings from grass treated with OVERTAKE® can be safely used for mulch after the third cut. An interval of four weeks must elapse between application of OVERTAKE® and re-seeding turf. Do not apply if turfgrass is wet. Do not apply to turf, lawns or grass areas which are under stress. |
Personal Protective Equipment |
Eye Protection: Always wear eye protection when the potential for inadvertent eye contact with the product cannot be excluded. Tightly fitting safety goggles. Face-shield
Hand Protection: Nitrile rubber 0.5mm thick |
Application Advice
Tank mixing |
Highly compatible |
---|---|
Mixing and spraying |
Half fill the spray tank with water and add the required amount of OVERTAKE®. Fill up the spray tank, agitating continuously to ensure thorough mixing, and maintain agitation until spraying is complete. Use only clean water for mixing. APPLICATION OVERTAKE® may be applied through tractor-mounted hydraulic sprayers or knapsack sprayers providing they are in good working order and have been calibrated according to the manufacturers’ recommendations. Apply OVERTAKE® as a MEDIUM spray as defined by the BCPC system. Do not apply through CDA applicators. TANK CLEANING To avoid subsequent injury to crops other than managed amenity turf, domestic lawns and amenity grassland, all spraying equipment must be thoroughly cleaned both inside and out, using All Clear Extra spray cleaner as follows: 1) Immediately after spraying, drain tank completely. Any contamination on the outside of the spraying equipment should be removed by washing with clean water. 2) Rinse inside of tank with clean water and flush through booms and hoses using at least one tenth of the spray tank volume. Drain tank completely. 3) Half fill tank with clean water and add All Clear Extra at the recommended rate. Agitate and then briefly flush the booms and hoses with the cleaning solution. Top up with water making sure the tank is completely full and allow to stand for 15 minutes with agitation. Flush the booms and hoses and drain tank completely. 4) Nozzles and filters should be removed and cleaned separately with All Clear Extra solution containing 50 ml of All Clear Extra per 10 litres of water. 5) Rinse the tank with clean water and flush through the booms and hoses using at least one tenth of the spray tank volume. Drain tank completely. 6) For disposal of washings, follow The Code of Practice for Using Plant Protection Products. Do not spray onto sensitive crop or land intended for cropping with sensitive crop. Note: If it is not possible to drain the tank completely, step 3 must be repeated before going onto step 4. |
Water volume |
OVERTAKE® may be applied through tractor-mounted hydraulic sprayers or knapsack sprayers. For overall application, apply OVERTAKE® in 200 to 400 litres of water per hectare. For knapsack application, apply OVERTAKE® in 2 to 4 litres of water per 100 m2. |